Improved circuit design. better components and lower electrical noise!
DJI HD VTX Connector (Plug-and-Play / No soldering required)
FC indicator LEDs for visual debugging
With LC filter
MCU: STM32 F722
Gyro: BMI270
Barometer: DPS310
OSD Chip: AT7456E
Flash: 32MB (Blackbox flash)
UARTS: 6
Motor outputs: 4x (SH1.0 connector)
I2C serial: SDA / SLA pads
Smartaudio / IRC Tramp VTX protocol supported
LED controller: Yes
Beeper pad: Yes
Firmware target: IFRC-IFLIGHT_BLITZ_F722
Mount pattern: 30.5*30.5mm / 4mm PCB hole diameter
Dimensions: 36.5*35 mm
Weight: 7.8g
BEC: 5V 2.5A / 9V 2A
UART 1 for VTX HD / Analog
UART 2 for a Receiver
UART 3/4/5 for GPS or other sensors that require a serial port
UART 6 for ESC Telemetry
Supports: DShot150/300/600/MultiShot/ OneShot etc.
Mounting Holes: 30.5*30.5mm/Φ4mm
Supports 2-6S lipo input
Telemetry Output: NO
Target: Q-H-25 16.7
Current sensor: Yes
Constant: 45 Amps
Current rate: 200
Burst: 55 Amps
Weight: 14.7g
MCU: BB21
BEC: NO
1 x BLITZ F7 V1.1 Flight Controller
1 x BLITZ E45S 4-IN-1 45A 2-6S ESC
1 x silicon grommets
1 x wire harness for F7 Flight controller