Pixhawk PX4 PRO PIX 32 Bit Flight Controller Autopilot SPECIFICATIONS

Wheelbase: Bottom Plate

Use: Vehicles & Remote Control Toys

Upgrade Parts/Accessories: Frame

Tool Supplies: Assembled class

Technical parameters: KV1100

Size: 80*48*15

Remote Control Peripherals/Devices: Remote Controller

Recommend Age: 12+y.14+y

RC Parts & Accs: Motor Components

Quantity: 1 pcs

Origin: Mainland China

Model Number: PIXHAWK PRO

Material: EVA

Four-wheel Drive Attributes: Assemblage

For Vehicle Type: Airplanes

Brand Name: rctosky

PIXHAWK PRO

Features:

Pixhawk PRO support the latest official ardupilot firmware and PX4 firmware.

1. The advanced 32-bit ARM CortexM4 high-performance processors(2MB flash). can run NuttX RTOS real-time operating system;

2. 14 PWM / servo output;

3. Bus interface (UART. I2C. SPI. CAN);

4. The integrated backup power and backup controller fails. the primary controller fails over to the backup control is safe;

5. Provide automatic and manual modes;

6. Provide redundant power input and failover;

7. Multicolor LED lights;

8. Provide multi-tone buzzer Interface

9. Micro SD recording flight data;

10.TYPE-C USB port

11.GH1.25 port

Specifications:

Interface

1.5 high voltage compatible UART 1. 2 with hardware flow control

2. 2 CAN

3.Spektrum DSM / DSM2 / DSM-X satellite receiver compatible input

4.Futaba SBUS compatible inputs and outputs

5.PPM Signal Input

6.RSSI (PWM or voltage) Input

7.I2C

8.SPI

9.3.3 and 6.6VADC input

10. External TYPEC USB Interface

The Pixhawk supports the latest ArduPilot and PX4 firmware versions. including 2.4.8 and PRO. It features a dedicated GH port with a locking mechanism for a more stable connection and a TYPE-C USB interface for reliable communication.

PIXHAWK PRO AUX OuT- OUT 32 pixdnuwk FMU PRO PWR FWR BE BTE ACT SPKTDSM BUZZER TELEM Switch Serial4/5 TYPE-C USB TeLEM GPS USB ADC 3 3v CAN SpI 12C POWER AdcG6

The Pixhawk PX4 PRO flight controller has interchangeable functions. allowing it to be used as both a ground station and an airborne terminal.

OLED Module can display some message.

Warning: Not configured. Fault message mode: stable flight modes unavailable. Battery level: 0% ( BAT1). Current: 0.00 uA. Voltage: unknown. GPS: no GPS signal available. GPS quantity: unknown. Pre-arm failed. EKF not initialized.